User Manual

25
4.2.9 I/O Control (See Figure 4-7)
The I/O Control page can be accessed by clicking the I/O Control tab in the
software, and is shown in Figure 4-7. The I/O Control page can be used to
read analog and digital inputs and set digital outputs.
Figure 4-7. I/O Control
Digital I/O
• Set Output – Sets pins configured as digital outputs to the selected
level (0 or 1).
• Query Input – Gets the input level (0 or 1) for pins configured as
digital inputs.
Analog Inputs
• Readings – Displays analog input values read by the microcontroller
for pins configured as analog inputs. The analog readings are taken
using the settings in the Analog Config tab (Section 4.2.8).