User Manual

37
2. Set I/O Sleep State – This message defines the state that the I/O
pins will be put into when the low power sleep mode of operation is
requested for the module. Similar to the “Set I/O Configuration”
message, the direction of the pin, whether or not the pull-up or pull-
down resistors are enabled for input pins, and the output value for
output pins can be configured. Upon exiting sleep mode the pins will
be configured back to the state they were in prior to entering sleep
mode.
3. Set Analog Input ADC Settings
– This message is used to set up
how the ADC conversion will be done for pins configured as analog
inputs. The settings include the reference voltage that the
conversion is based on, the resolution of the ADC conversion, and
the number of samples to average when a reading is taken. Note
that the higher the ADC conversion resolution the longer it takes to
do a conversion.