User's Manual
Table Of Contents
- Scope
- M2US50NBT/M2SD50NBT Features Summary
- Specifications
- WLAN Functional Description
- Bluetooth Functional Description
- Electrical Characteristics
- Bluetooth Radio Characteristics
- SDIO Timing Requirements
- Pin Definitions
- Mechanical Specifications
- Mounting
- Reference Schematic of M2US50NBT
- RF Layout Design Guidelines/Precautions
- Regulatory
- FCC and IC Regulatory
- European Union Regulatory
- EU Declarations of Conformity
- Ordering Information
M2US50NBT/M2SD50NBT
Hardware Integration Guide
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/wireless
5
Laird
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852-2268-6567 x026
Feature
Description
Sleep regulated and gated to enable the internal crystal to be powered down when
the device is in sleep mode
BT shares the clock from the Wi-Fi chip.
Wi-Fi cannot be turned off or put in reset state when running BT.
32.768 KHz slow clock is needed for BT to get into deep sleep mode.
Advanced WLAN
Includes the following advanced WLAN features:
IEEE 802.11e QoS, Wi-Fi Alliance WMM
Power Save, and 802.11n power saving
compliance
AES, AES-CCMP, TKIP engines for faster
data encryption
Cisco CCXv4 ASD, WPS support
Standard WEP/WPA/WPA2 for personal
and enterprise environments support
WWR, 802.11d, 802.11h support
Wi-Fi Direct (Peer-to-Peer)
RTT for indoor positioning
Statistics and events for monitoring
Self-managed power state
handling
Self-contained beacon
processing
Shared authentication
Ad-hoc power save
Multiple PMK ID support
Simulated UAPSD
T-Spec support
Production flow diagnostics
3-wire scheme for Wi-Fi and BT
coexistence.
Advanced
Bluetooth
High-speed UART port (up to 4 Mbps)
HFP v1.6 wide-band speech supported on-chip
On-chip encoding of SBC and aptX® codecs for A2DP music streaming
PCM/I2S digital audio interface
Support for IEEE 802.11 coexistence
The flexible RAM/ROM based architecture enables custom or future profiles to be
easily added
SPECIFICATIONS
Table 2: Specifications
Feature
Description
Physical Interface
PCI Express NGFF card type 2230-S3-E (2230 = 22mm x 30 mm, S3 = single
side, E = key ID)
Note: The M2US50NBT and M2SD50NBT are type 2230-S3-E, but the top
side component height is 2.5 mm max. The standard top side
height for S3 is 1.5 mm max.
Mating connector – (Kyocera) part number: 24-6411-067-101-897E
Stand-off – (EMI STOP) part number: F50M16-041525P1D4M
Wi-Fi Interface
M2SD50NBT – 1-bit or 4-bit Secure Digital I/O
M2US50NBT – USD 2.0
Bluetooth Interface
Host Controller Interface (HCI) using High Speed UART
Main Chip
Wi-Fi – Qualcomm Atheros QCA6004
BT – Cambridge Silicon Radio Ltd. (CSR) CSR8811 A08