User's Manual

FreeStar ZFSM-101-3
Page 15
AGENCY CERTIFICATIONS (Continued)
Section 14 of RSS-210
The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF eld in
excess of Health Canada limits for the general population. Consult Safety Code 6, obtainable from Health Canada's
website: http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/99ehd-dhm237/index-eng.php
L'article 14 du CNR-210
Le programme d'installation de cet équipement radio doit s'assurer que l'antenne est située ou orientée de telle sorte qu'il
ne pas émettre de champ RF au-delà des limites de Santé Canada pour la population générale. Consulter le Code de
sécurité 6, disponible sur le site Web de Santé Canada: http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/99ehd-dhm237/
index-eng.php
EMC Certication
FCC Part 15.247 Module Certied (Portable)
EN 300 328 1 Certied / CE Approved
The FreeStar Module has been tested and certied for the European Union.
OEM Responsibility to the European Union Compliance Rules
If the FreeStar Module is to be incorporated into a product, the OEM must verify compliance of the nal product to the Eu-
ropean Harmonized EMC and Low-Voltage/Safety Standards. A Declaration of Conformity must be issued for each of these
standards and kept on le as described in Annex II of the R&TTE Directive.
The manufacturer must maintain the user's guide and adhere to the settings described in the manual for maintaining
European Union Compliance. If any of the specications are exceeded in the nal product, the OEM is required to
make a submission to the notied body for compliance testing.
OEM Labeling Requirements
The `CE' mark must be placed on the OEM product in a visible location. The CE mark shall consist of the initials “CE” with
the following form:
• If the CE marking is reduced or enlarged, the proportions given in the above graduated
drawing must be adhered to
• The CE mark must be a minimum of 5mm in height
• If the use of the module is subject to restrictions in the end application, the CE marking on the
OEM product should also include the alert sign as shown in the picture to the right
Australia Certication
Number: AS/NZS 4268