User's Manual

FreeStar ZFSM-101-3
Page 14
AGENCY CERTIFICATIONS
FCC Compliance Statement (Part 15.19) Section 7.15 of RSS-GEN
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received, including interference that may cause undesired operation
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement
Warning (Part 15.21)
Changes or modications not expressly approved by CEL could void the user's authority to operate the equipment.
20 cm Separation Distance
To comply with FCC/IC RF exposure limits for general population/uncontrolled exposure, the antenna(s) used for this trans-
mitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.
OEM Responsibility to the FCC Rules and Regulations
The FreeStar Module has been certied per FCC Part 15 rules for integration into products without further testing or certi-
cation. To fulll the FCC certication requirements, the OEM of the FreeStar Module must ensure that the
information provided on the FreeStar Label is placed on the outside of the nal product. The FreeStar Module is labeled
with its own FCC ID Number. If the FCC ID is not visible when the module is installed inside another device, then the out-
side of the device into which the module is installed must also display a label referring to the enclosed module. This exterior
label can use wording such as the following: “Contains Transmitter Module FCC ID: TFB-FREESTAR3” or “Contains FCC ID:
TFB-FREESTAR3”
The OEM of the FreeStar Module must only use the approved antenna, that has been certied with this module. The OEM
of the FreeStar Module must test their nal product conguration to comply with Unintentional Radiator Limits before declaring
FCC compliance per Part 15 of the FCC rules.
IC Certication — Industry Canada Statement
The term "IC" before the Certication/Registration number only signies that the Industry Canada technical specications
were met.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two con-
ditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Certication IC - Déclaration d'Industrie Canada
Le terme "IC" devant le numéro de certication/d'enregistrement signie seulement que les spécications techniques
Industrie Canada ont été respectées.-
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur
de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement