User's Manual

BT900-US Hardware Integration Guide
Intelligent BTv4.0 Dual Mode Module
Embedded Wireless Solutions Support
Embedded Wireless Solutions Support Embedded Wireless Solutions Support
Embedded Wireless Solutions Support
Center:
Center: Center:
Center: http://ews
http://ewshttp://ews
http://ews-
--
-support.lairdtech.com
support.lairdtech.comsupport.lairdtech.com
support.lairdtech.com
www.lairdtech.com/bluetooth
Laird Technologies
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]
5 O RDERING I NFORMATION
Part
PartPart
Part N
NN
Number
umberumber
umber Description
DescriptionDescription
Description
BT900
-
US
Single Mode
Pluggable USB
BLE Module featuring
smart
BASIC
–
integrated
antenna
5.1 General Comments
This is a preliminary datasheet. Please check with Laird for the latest information before commencing a design.
If in doubt, ask.
6 B LUETOOTH SIG Q UALIFICATION
The BT900-US module is listed on the Bluetooth SIG website as qualified End Products.
Design
Design Design
Design
Name
NameName
Name
Owner
OwnerOwner
Owner
Declaration
Declaration Declaration
Declaration
ID
IDID
ID
L
LL
Link to listing on the SIG website
ink to listing on the SIG websiteink to listing on the SIG website
ink to listing on the SIG website
BT900
Laird
Technologie
s
D023116 https://www.bluetooth.org/tpg/QLI_viewQDL.cfm?qid=23116
It is a mandatory requirement of the Bluetooth Special Interest Group (SIG) that every product implementing
Bluetooth technology has a Declaration ID. Every Bluetooth design is required to go through the qualification
process, even when referencing a Bluetooth Design that already has its own Declaration ID. The Qualification
Process requires each company to registered as a member of the Bluetooth SIG – www.bluetooth.org
The following link provides a link to the Bluetooth registration page:
https://www.bluetooth.org/login/register/
For each Bluetooth Design it is necessary to purchase a Declaration ID. This can be done before starting the
new qualification, either through invoicing or credit card payment. The fees for the Declaration ID will depend
on your membership status, please refer to the following webpage:
https://www.bluetooth.org/en-us/test-qualification/qualification-overview/fees
For a detailed procedure of how to obtain a new Declaration ID for your design, refer to the following
document: https://www.bluetooth.org/DocMan/handlers/DownloadDoc.ashx?doc_id=283698&vId=317486
To start the listing, go to: https://www.bluetooth.org/tpg/QLI_SDoc.cfm
In step 1, select the option, Reference a Qualified Design
Reference a Qualified DesignReference a Qualified Design
Reference a Qualified Design and enter xXXXX in the End Product table entry.
You can then select your pre-paid Declaration ID from the drop down menu or go to the Purchase
Declaration ID page.
Note:
Note:Note:
Note: Unless the Declaration ID is pre-paid or purchased with a credit card, you cannot proceed until the
SIG invoice is paid.
Once all the relevant sections of step 1 are finished, complete steps 2, 3, and 4 as described in the help
document. Your new Design will be listed on the SIG website and you can print your Certificate and DoC.
For further information please refer to the following training material:
https://www.bluetooth.org/en-us/test-qualification/qualification-overview/listing-process-updates