User's Manual

BT900-Sx Hardware Integration Guide
Intelligent BTv4.0 Dual Mode Module
Americas: [phone] Option 2
Europe: [phone]
Hong Kong: [phone]
www.lairdtech.com/bluetooth
47 CONN-HIG-BT900
13 O RDERING I NFORMATION
Part Number DESCRIPTION
BT900
-
SA
-
0x
Single Mode BLE Module featuring
smart
BASIC
–
integrated antenna
BT900
-
SC
-
0x
Single Mode BLE Module featuring
smart
BASIC
–
IPEX MHF4 connector
DVK
–
BT900
-
SA
-
0x
Development board with
BT900
-
SA
module soldered in place
DVK
–
BT900
-
SC
-
0x
Development board with
BT900
-
SC
module soldered in place
13.1 General Comments
This is a preliminary datasheet. Please check with Laird for the latest information before
commencing a design. If in doubt, ask.
14 B LUETOOTH SIG Q UALIFICATION
The BT900 module is listed on the Bluetooth SIG website as qualified End Products.
Design
Name
Owner
Declaratio
n ID
Link to listing on the SIG website
BT900 Laird
Technologie
s
TBC https://www.bluetooth.org/tpg/QLI_viewQDL.cfm?qid=
20700
It is a mandatory requirement of the Bluetooth Special Interest Group (SIG) that every product
implementing Bluetooth technology has a Declaration ID. Every Bluetooth design is required to
go through the qualification process, even when referencing a Bluetooth Design that already has
its own Declaration ID. The Qualification Process requires each company to registered as a
member of the Bluetooth SIG – www.bluetooth.org
The following link provides a link to the Bluetooth Registration page:
https://www.bluetooth.org/login/register/
For each Bluetooth Design it is necessary to purchase a Declaration ID. This can be done before
starting the new qualification, either through invoicing or credit card payment. The fees for the
Declaration ID will depend on your membership status, please refer to the following webpage:
https://www.bluetooth.org/en-us/test-qualification/qualification-overview/fees
For a detailed procedure of how to obtain a new Declaration ID for your design, please refer to
the following SIG document:
https://www.bluetooth.org/DocMan/handlers/DownloadDoc.ashx?doc_id=283698&vId=317486
To start the listing, go to: https://www.bluetooth.org/tpg/QLI_SDoc.cfm
In step 1, select the option, Reference a Qualified Design and enter 20700 in the End Product
table entry. You can then select your pre-paid Declaration ID from the drop down menu or go
to the Purchase Declaration ID page, (please note that unless the Declaration ID is pre-paid or
purchased with a credit card, it will not be possible to proceed until the SIG invoice is paid.