User's Manual
Table Of Contents
- Revision History
- Contents
- 1 Scope
- 2 Operational Description
- 3 Block Diagram and Descriptions
- 4 Specifications
- 5 Pin Definitions
- 6 DC Electrical Characteristic
- 7 RF Characteristics
- 8 Interface
- 9 Power Supply and Regulation
- 10 Antenna Performance
- 11 Mechanical Dimensions and Land Pattern
- 12 Implementation Note
- 13 Application Note for Surface Mount Modules
- 14 FCC and IC Regulatory
- 15 European Union Regulatory
- 16 Ordering Information
- 17 Bluetooth SIG Approvals
2006/8/16 v1.0
(For transmitters equipped with detachable antennas)
This radio transmitter (identify the device by certification number, or model number if
Category II) has been approved by Industry Canada to operate with the antenna types
listed below with the maximum permissible gain and required antenna impedance for each
antenna type indicated. Antenna types not included in this list, having a gain greater than
the maximum gain indicated for that type, are strictly prohibited for use with this device.
Le présent émetteur radio (IC:3147A-BT830) a été approuvé par Industrie Canada pour
fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible
maximal et l'impédance requise pour chaque type d'antenne. Les types d'antenne non
inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont
strictement interdits pour l'exploitation de l'émetteur.
Type Manufacture Gain Connector
Chip
ACX (Advanced Ceramic X
Corp.)
0.5dBi
N/A
Dipole
Nearson 2.0 dBi IPEX u.FL
PCB Dipole
Laird Technologies 2.0 dBi
IPEX u.FL
Dipole
Laird Technologies 2.0 dBi
IPEX u.FL
Dipole
Laird Technologies 1.5 dBi
IPEX u.FL