User's Manual

Class 1 Bluetooth v2.0 Module
User’s Guide
Americas: [phone] Option 2
Europe: [phone]
Hong Kong: [phone]
www.lairdtech.com/bluetooth
24
CONN-GUIDE-BT730_v0.9
Reg.
#
Defaul
t
Range
Comment
S100
15
0..15
Number of RING indications before an auto disconnection is initiated.
A value of 0 disables this feature.
If S0 <> 0 and S100 <> 0 then S0 must be < S100. If a value is
entered which violates this rule, then ERROR 29 is sent in response.
S101
$1101
0..$ffff
UUID of default SPP based profile when not specified explicitly in the
ATD command.
S102
1
1..$7F
Defines a set of bits masks for enabling profile servers. Values can
be ORed.
 1 is Serial Port Profile
 2 is Headset ( S Reg 580 allows remote volume control bit to
be adjusted)
 4 is DUN
 8 is Audio Gateway (Headset)
 16 is Handsfree (S Reg 581 allows supported feature field to be
adjusted)
 32 is OBEX FTP
 64 is Audio Gateway (Handsfree)
It is recommended that, due to memory resource issues, no more
than two profiles are activated at the same time.
S103
1
1..7
Boot mode on cold boot.
S126
?
0 .. 0xFFFF
Primer for changing to Multipoint mode
S127
?
0 .. 0xFFFF
0x100 for AT mode
0x200 for Multipoint mode
Other values are reserved
S400
0
0..1
Piodeamon.
1 = Hostless Audio gateway Operation
S401
1000
100..5000
In Hostless Audio Gateway Operation – GPIO4 flash period while
inquiring
S402
0
0..100
In Hostless Audio Gateway Operation – GPIO4 flash duty cycle while
inquiring
S403
1000
100..5000
In Hostless Audio Gateway Operation – GPIO4 flash period when
there is an ACL connection only to the headset
S404
0
0..100
In Hostless Audio Gateway Operation – GPIO4 flash duty cycle when
there is an ACL connection only to the headset
S405
1000
100..5000
In Hostless Audio Gateway Operation – GPIO4 flash period when
there is an ACL and SCO connection to the headset
S406
0
0..100
In Hostless Audio Gateway Operation – GPIO4 flash duty cycle when
there is an ACL and SCO connection to the headset
S407
0
0..1
In Hostless Audio Gateway Operation – ‘Lift-Hook’ output follows
SCO state
S408
0
0..1
In Hostless Audio Gateway Operation – if set to 1 then delete trusted
device database when inquiry is initiated to look for headsets