User's Manual
Table Of Contents
- 1 Overview and Key Features
- 2 Specification
- 2.1 Specification Summary
- 3 Hardware Specifications
- 3.3.4 OTA (Over-the-Air) smartBASIC Application Download
- 4 Power Consumption
- 5 Functional Description
- 5.1 Power Management (includes Brown-out and Power on Reset)
- 5.2 Clocks and Timers
- 5.3 Memory for smartBASIC Application Code
- 5.4 Radio Frequency (RF)
- 5.5 NFC
- 5.6 UART Interface
- 5.7 SPI Bus
- 5.8 I2C Interface
- 5.9 General Purpose I/O, ADC, PWM and FREQ
- 5.10 nRESET pin
- 5.11 nAutoRUN pin
- 5.12 vSP Command Mode
- 5.13 Two-wire Interface JTAG
- 5.14 BL652 Wakeup
- 5.15 Low Power Modes
- 5.16 Temperature Sensor
- 5.17 Random Number Generator
- 5.18 AES Encryption/Decryption
- 5.19 Optional External Serial (SPI) Flash
- 5.20 Optional External 32.768 kHz crystal
- 5.21 BL652-SA On-board Chip Antenna Characteristics
- 6 Hardware Integration Suggestions
- 7 Mechanical Details
- 8 Application Note for Surface Mount Modules
- 9 FCC and IC Regulatory Statements
- 10 Japan (MIC) Regulatory
- 11 CE Regulatory
- 12 EU Declarations of Conformity
- 13 Ordering Information
- 14 Bluetooth SIG Qualification
BL652
Datasheet
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/bluetooth
9
© Copyright 2016 Laird. All Rights Reserved
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0610
3 HARDWARE SPECIFICATIONS
Block Diagram and Pin-out
Figure 1: BL652 Block diagram
Figure 2: Functional HW and SW block diagram for BL652 series BLE smartBASIC module