User's Manual

BL652
Datasheet
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/bluetooth
66
© Copyright 2016 Laird. All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]
3. Enter TBD or TBD in the End Product table entry.
4. Select your pre-paid Declaration ID from the drop down menu or go to the Purchase Declaration ID page.
Note: Unless the Declaration ID is pre-paid or purchased with a credit card, you cannot proceed until the SIG
invoice is paid.
5. Once all the relevant sections of step 1 are finished, complete steps 2, 3, and 4 as described in the help
document accessible from the site.
Your new design will be listed on the SIG website and you can print your Certificate and DoC.
For further information please refer to the following training material:
https://www.bluetooth.org/en-us/test-qualification/qualification-overview/listing-process-updates
Note: If using the BL652 with Laird Firmware and smartBASIC script, you can skip Controller Subsystem, Host
Subsystem, and Profile Subsystem.
Qualification Steps When Deviating from a Laird End Product Design
If you wish to deviate from the standard End Product designs listed under TBD or TBD, the qualification process
follows the New Listing route (without referencing a Qualified Design). When creating a new design it is
necessary to complete the full qualification listing process and also maintain a compliance folder for the design.
If your design is based on un-modified BL652 hardware, follow these steps:
1. Reference the existing RF-PHY test report from the BL600 listing.
Note: This report is available from Laird: [e-mail]
2. Combine the relevant Nordic Link Layer (LL).
3. Combine in a Host Component (covering L2CAP, GAP, ATT, GATT, SM).
4. Test any standard SIG profiles that are supported in the design, (customs
profiles are exempt).
The first step is to generate a project on the TPG (Test Plan Generator) system, select
‘Traditional Project’. This determines which test cases apply to demonstrate
compliance with the Bluetooth Test Specifications, from the TPG you generate a Test
Declaration, (Excel format). If you are combining pre-tested and qualified
components in your design, and they are within their 3 year listing period, you are
not required to re-test those layers covered by those components.
Figure 20: Scope of the qualification for an End Product Design.
End
Product
Laird RF-PHY
Nordic LL
Host
Layers
Profiles