User Manual

APEX/APEX LT
Datasheet (Preliminary Rev 0.2) www.lsr.com Page 14 of 20
is responsible for passing the additional FCC part 2.1093 rules (SAR) and FCC Guidelines for
Human Exposure to Radio Frequency Electromagnetic Fields, OET Bulletin and Supplement C.
The labeling requirements for Industry Canada are similar to those of the FCC. A visible label
on the outside of the final product must display the IC labeling. The user is responsible for the
end product to comply with IC ICES-003 (Unintentional radiators).
The APEX and APEX LT modules have been certified per EN 300-328-1 for use in European
countries. The user must ensure compliance of any final product to the European harmonized
EMC and safety standards. Annex II of the R&TTE Directive gives the requirements for the
issuance of a Declaration of Conformity.
The CE marking must be affixed legibly and indelibly to a visible location on the user’s
product.
To meet the EN 300-328-1 power spectral density requirements of Clause 4.3.2.2, the
maximum transceiver power setting for the APEX module and the APEX LT module are as
follows:
Maximum transceiver power setting for APEX CE approval
Channel 11 (2405 MHz) - Channel 22 (2460 MHz) -15
Channel 23 (2465 MHz) – Channel 26 (2480 MHz) -20
Maximum transceiver power setting for APEX LT CE approval
TBD
12.1 FCC approved antennas
Integrated PCB trace antenna
Nearson S131CL-5-RMM-2450S
A 2.4GHz Dipole antenna with a 5 inch cable and a right angle MMCX
connector.