User Manual

APEX/APEX LT
Datasheet (Preliminary Rev 0.2) www.lsr.com Page 13 of 20
12 Agency Certifications
FCC Part 15.247 Module Certified (Mobile)
The APEX and APEX LT modules comply with Part 15 of the Federal Communications
Commission rules and regulations. To meet the FCC Certification requirements, the user must
meet these regulations.
• The text on the FCC ID label provided with the module is placed on the outside of the
final product.
• The modules may only use the antennas that have been tested and approved with this
module.
o The on-board PCB trace antenna
o Nearson S131CL-5-RMM-2450S antenna.
To meet the section 15.209 emission requirements in the restricted frequency bands of section
15.205, the maximum transceiver transmitter power setting for both the APEX (EM250) and
APEX LT (EM260) modules vary depending on the channel used within the band of operation
as follows:
APEX module using external antenna – maximum channel power setting
Channel 11 (2405 MHz) -4
Channel 12 (2410 MHz) – Channel 23 (2465 MHz) 3
Channel 24 (2470 MHz) -7
Channel 25 (2475 MHz) -14
Channel 26 (2480 MHz) -2b
APEX module using on board PCB trace antenna – maximum channel power setting
Channel 11 (2405 MHz) – Channel 24 (2470 MHz) 3
Channel 25 (2475 MHz) -12
Channel 26 (2480 MHz) -2b
APEX LT module using either external or PCB trace antenna – maximum channel power
setting
Channel 11 (2405 MHz) – Channel 24 (2470 MHz) 0
Channel 25 (2475 MHz) -10
Channel 26 (2480 MHz) -26
Per section 2.109, the APEX and APEX LT modules have been certified by the FCC for use with
other products without additional certification. Any modifications to this product may violate
the rules of the Federal Communications Commission and make operation of the product
unlawful.
Per sections 15.107 and 15.109, the user’s end product must be tested to comply with
unintentional radiators for compliance.
Per Section 47 C.F.R. Sec.15.105(b), the APEX and APEX LT modules are certified as a mobile
device for the FCC radiation exposure limits set forth for an uncontrolled environment. The
antenna used with this module must be installed to provide a separation distance of at least 8
inches (20cm) from all persons. If the module is to be used in a handheld application, the user