User's Manual

60-2230C
Datasheet
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/wireless
38
© Copyright 2017 Laird. All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]
18. FCC AND IC R EGULATORY
Model
US/FCC
CANADA/IC
60
-
2230C
SQG
-
60
2230C
3147A
-
60
2230C
The 60-2230C has been designed to pass certification with the antenna listed below. The required antenna
impedance is 50 ohms.
Table 21: FCC antenna information
Model Type Connector
Peak gain ( dBi )
2400~2483.5
MHz
5150~5250
MHz
5250~5350
MHz
5470~5725
MHz
5725~5850
MHz
Laird
MAF94051
Dipole RP-SMA 2.1 dBi 2.4 dBi 2.6 dBi 3.4 dBi
Laird
NanoBlade-IP04
PCB Dipole IPEX MHF 2 dBi 3.9 dBi 4 dBi
Laird
MAF95310 Mini
NanoBlade Flex
PCB Dipole IPEX MHF 2.79 dBi 3.38 dBi
Laird
NanoBlue-IP04
PCB Dipole IPEX MHF 2dBi _
Ethertronics
WLAN_1000146
Isolated
Magnetic
Dipole
IPEX MHF 2.5dBi
4.5 dBi
18.1 FCC
18.1.1 Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the following
measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
18.1.2 FCC Caution
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.