User's Manual

SU60-SIPT
Datasheet
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/wireless
41
© Copyright 2017 Laird. All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]
15.3 Surface Mount Conditions
The following soldering conditions are recommended to ensure device quality.
15.3.1 Soldering
Note: When soldering, the stencil thickness should be ≥ 0.1 mm.
Convection reflow or IR/Convection reflow (one-time soldering or two-time soldering in air or nitrogen
environment)
 Measuring point – IC package surface
 Temperature profile:
Figure 13 Temperature profile