User's Manual

SU60-SIPT
Datasheet
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/wireless
34
© Copyright 2017 Laird. All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]
Symbol Parameter Min. Typ. Max. Unit
T DO - - - 30 ns
T DISU - 15 - - ns
T DIHO - 10 - - ns
T BFSU - 15 - - ns
T BFHO - 10 - - ns
11 P IN D EFINITIONS
Note: AVDD18 is generated by PMU internally. No need to power from outside the SIP.
Table 33: Pin definitions of 60-SIPT series
Pin
#
Name Type
Voltage
Ref.
Description
If Not
Used
1 PDn I -
Full Power-Down (input) (Active low)
0=full power-down mode; 1=normal mode
PDn can accept an input range from 1.8V to 3.6V
PDn must be high for normal operation. Please
connect to pin-32 (1.8V_OUT) through 49.9KΩ.
--
2 GND - - Ground GND
3 GND - - Ground GND
4 ANT0 (Wi-Fi/BT) A,I/O -
RF Transmit/Receive
Wi-Fi and BT share the same path.
50Ω
Load
5 GND - - Ground GND
6 GND - - Ground GND
7 GND - - Ground GND
8 GND - - Ground GND
9 GND - - Ground GND
10 GND - - Ground GND
11 GND - - Ground GND
12 ANT1 (Wi-Fi only) A,I/O -
RF Transmit/Receive
Wi-Fi only
50Ω
Load
13 GND - - Ground GND
14 GND - - Ground GND
15 CONFIG_HOST2 I, PU AVDD18
Host interface configuration setting.
Detail configuration table are shown in Table 32
To set a configuration bit to “0”, attach a 100kΩ
resistor from the pin to ground.
No external circuitry is required to set a
configuration bit to “1”.
-
16 CONFIG_HOST1 I, PU AVDD18
Host interface configuration setting.
Detail configuration table are shown in Table 32
To set a configuration bit to “0”, attach a 100kΩ
resistor from the pin to ground.
-