User's Manual

RG191-M2 Concentrator Card
Datasheet
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/wireless
7
© Copyright 2017 Laird. All Rights Reserved
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0610
6 FCC AND IC REGULATORY STATEMENTS
Model
US/FCC
CANADA/IC
RG191-M2
SQG-1001
3147A-1001
The OEM must follow the regulatory guidelines and warnings listed below to inherit Laird’ modular approval.
The RG191-M2 holds full modular approvals and has been certified for integration to products only by OEM
integrators under the following conditions:
1. The antenna(s) must be installed such that a minimum separation distance of 20 cm is always maintained
between the radiator (antenna) and all persons.
2. The transmitter module must not be operating in conjunction with any other antenna or transmitter, except
in accordance with FCC multi-transmitter product procedures.
If the two conditions above are met, further transmitter testing will not be required. However, the OEM
integrator is still responsible for testing their end-product for any additional compliance requirements required
with this module installed (for example, digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: If these conditions cannot be met (for certain configurations or co-location with another
transmitter), then the FCC and Industry Canada authorizations are no longer considered valid and the FCC ID and
IC Certification Number cannot be used on the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC and
Industry Canada authorization.
Power Exposure Information
Federal Communication Commission (FCC) Radiation Exposure Statement:
To comply with FCC RF exposure limits for general population/uncontrolled exposure, the antenna(s) used for
this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and
operating in conjunction with any other antenna or transmitter.
OEM Responsibilities
WARNING: The OEM must ensure that FCC and Industry Canada labelling requirements are met. This includes a
clearly visible label on the outside of the OEM enclosure specifying the appropriate Laird FCC
identifier for this product.
Contains FCC ID: SQG-1001
Contains IC: 3147A-1001
The OEM of the RG191-M2 module must only use the approved antenna(s) listed above (TBD),
which have been certified with this module. The OEM integrator must not provide information to
the end user regarding how to install or remove this RF module or change RF related parameters in
the user manual of the end-product.
The user manual for the end-product must also include the following information in a prominent
location:
To comply with FCC and Industry Canada RF exposure limits for general population/uncontrolled
exposure, the antenna(s) used for this transmitter must be installed to provide a separation distance
of at least 20 cm from all persons and operating in conjunction with any other antenna or
transmitter, except in accordance with FCC multi-transmitter product procedures.