Installation Instructions

Aversan Inc.
Rev. 1.0 Page 8 of 9
Configurations and External Interfaces
The ADG-400 consists of a core unit and can include two replaceable module interfaces (RMIs).
Core Unit
The core unit contains front and rear facing interfaces. All interfaces listed below are rear attached to
the rear panel except for those explicitly called out.
• 10x 10/100/1000M BaseT Ethernet ports
o 5x Connected to internal Ethernet switch
o 4x Isolated Ethernet ports directly connected to the CPU
o 1x Isolated Ethernet port directly connected to the CPU (Front panel)
• 18x ARINC 720 gnd/open discretes
o 12x Discrete inputs
o 6x Discrete outputs
• 2x RS-422 transceivers (TX and RX)
• 2x ARINC A429 transmitters
• 4x ARINC A429 receivers
• 1x USB 3.1 Gen 1 port (Front Panel)
• 1x SD Card (Front Panel)
• 1X 1TB SSD
• 4x Antenna connectors to support 2x2 MIMO configuration of WiFi and Cellular
• 2x Internal antennas (Front Panel)
• 1x WiFi + Bluetooth module
• 1x WiFi module
• 1x Cellular module
• 2x SIM slots (Front Panel)
• 2x LED status indicators (Front Panel)
Replacable Module Interfaces
There are 4 Replaceable Module Interfaces.
Ethernet Module
The Ethernet Module provides the following interfaces:
• 2x 10Base2 coaxial connectors (1 internal 10Base2 interface with built-in ‘Tee’ connection)
• 2x 10/100M BaseT Ethernet ports
ARINC Module
The ARINC Module provides the following interfaces:
• 2x ARINC A429 transmitters
• 4x ARINC A429 receivers