User's Manual

01/2001, CATTRON

- THEIMEG

Section 5, Page 15

Address, Frequency Bank, and Frequency report only, continued.

5. To find the present Frequency Bank value, press and release button #2. The controller will

emit one long beep to alert you, then will beep out the Frequency Bank setting count with

short beeps. The green LED will also flash with each beep/count. (‘0’ is represented by a

long beep with no LED flash). Look, listen, and count to determine the existing value. Repeat

as necessary by pressing button #2. See Table 5-1 above to convert number of ‘Beeps’ to

‘Frequency Bank’ setting.

6. To find the present Frequency value press and release button #3. The controller will emit one

long beep to alert you, then will beep out the Frequency setting count with short beeps. The

green LED will also flash with each beep/count. (‘0’ is represented by a long beep with no

LED flash). Look, listen, and count to determine the existing value. Repeat as necessary by

pressing button #3. See Table 5-1 above to convert number of ‘Beeps’ to ‘Frequency’

setting.

7. Set the ON/OFF switch on the PSEZ or CS controller to ‘OFF’, then set the switch to ‘ON’

again for normal operation. While in normal operating mode all buttons perform as labeled -

frequency and address will not change.

END OF SECTION