User's Manual

Section 5, Page 10 01/2001, CATTRON

- THEIMEG

Address digit #3 entry and report (PSEZ and CS controllers), continued.

4. To select Digit #3 (‘High’ digit on PSEZ controllers) Data Entry Mode, press and release

button #3. To find the present Address Digit #3 value, press and release button #4. The unit

will emit one long beep to alert you, then will beep out the Address Digit #3 setting count

with short beeps. (i.e., five short beeps if the Digit is ‘5’). The green LED will also flash with

each short beep/count. (‘0’ is represented by a long beep with no LED flash). Look, listen,

and count to determine the existing value. Repeat as necessary by pressing button #4. See

Address Table on page 7 of this section to convert number of ‘Beeps’ to ‘Address Digit’

setting.

5. To increment the Address Digit #3 press and release button #1. Each depression will

increment the Address Digit #3 by one, continuing from its present value until it reaches 15,

then will roll over to zero and start again. (The unit will beep each time button #1 is

depressed).

6. Press button #4 to confirm your desired setting.

7. Once you have entered the desired Address Digit #3, set the ON/OFF switch on the PSEZ or

CS controller to ‘OFF’ to permanently store the Address Digit #3.

Address digit #4 entry and report (PSEZ and CS controllers).

NOTES: (1) On the PSEZ Controller, address codes 00 and FF are not valid.

(2) On the PSEZ Controller, Digit #3 is the ‘High’ Digit and Digit #4

is the ‘Low’ Digit.

1. Referring to Figure 5-1 above, set the ON/OFF switch on the PS controller to ‘OFF’. Make

sure the red STOP Switch on the controller is unlatched and set to the ‘RUN’ (pulled up)

position.

NOTE: Provided a Frequency and Address has been programmed in the controller,

applying power to the controller with the red STOP Switch set to ‘STOP’

(pushed down) will immediately place the Controller in a STOP message

transmit cycle. If a Frequency and Address has not been pre-programmed in the

controller, the STOP message transmit cycle cannot be sent. Instead, the

controller will emit three long beeps and reset.

2. Press and hold down buttons #1 and #2 (see figure 5-1 above) and set ON/OFF switch to

‘ON’. Pause approximately for one second or until the green LED illuminates, then release

buttons #1 and #2. The controller will emit one long ‘beep’, which means you are now in the

Main Menu of the address and frequency program.

NOTE: The yellow LED will flash instead of the green LED when low battery voltage is

detected.