User's Manual

01/2001, CATTRON

- THEIMEG

Section 5, Page 7

Address digit #1 entry and report (CS controller only), continued.

2. Press and hold down buttons #1 and #2 and set ON/OFF switch to ‘ON’. Pause

approximately for one second or until the green LED illuminates, then release buttons #1 and

#2. The controller will emit one long ‘beep’, which means you are now in the Main Menu

of the address and frequency program.

NOTE: The yellow LED will flash instead of the green LED when low battery voltage is

detected.

3. Press and release button #1 (see Figure 5-1 above). The controller will emit one long ‘beep’

followed by one short ‘beep’ and the green LED will flash with the short ‘beep’. This

indicates you are now in the Address Data Entry and Report Mode.

4. To select Address Digit #1 Data Entry Mode, press and release button #1. To find the present

Address Digit #1 value, press and release button #4. The unit will emit one long beep to alert

you, then will beep out the Address Digit #1 setting count with short beeps. (i.e., three short

beeps if the Address Digit #1 is ‘3’). The green LED will also flash with each short

beep/count. (‘0’ is represented by a long beep with no LED flash). Look, listen, and count to

determine the existing value. Repeat as necessary by pressing button #4. See Address Table

below to convert number of ‘Beeps’ to ‘Address Digit’ setting.

Address Table – PSEZ & CS Controllers

NUMBER OF COUNTS OF

BEEPS AND GREEN LED

FLASHES ADDRESS DIGIT

0 = 0

1 = 1

2 = 2

3 = 3

4 = 4

5 = 5

6 = 6

7 = 7

8 = 8

9 = 9

10 = A

11 = B

12 = C

13 = D

14 = E

15 = F