User's Manual

Section 3, Page 10 01/2001, CATTRON

- THEIMEG

Operating Procedure – PS Controller, continued.

4. Press any large pushbutton. The PS Controller is now fully operational and transmitting a

signal as indicated by the green TRANSMIT LED flashing. Operate the pushbuttons and

switches as required, remembering that each large pushbutton must be maintained in order for

the function to continue to operate. Any or all functions may be operated simultaneously if the

controlled machine permits such operation.

NOTES: (1) A system STOP may be initiated at any time during the control

function by pushing the red STOP switch downwards.

(2) When all control functions have been completed, we recommend

you initiate a system STOP (push red STOP switch down) before

setting the ON/OFF switch to the ‘OFF’ position. This will prevent the

Mainline contactor from remaining energized for up to 10 minutes via

control of OPR.

END OF SECTION