User's Manual

01/2001, CATTRON - THEIMEG
TM
Section 3, Page 5
Battery Charging Options, continued.
Internal Charging. To re-charge the Ni-Cad Battery Pack within the controller, connect the
CATTRON-THEIMEG
™
battery charger to the mains power supply. Referring to Figure 3-3 below,
position the Pendant Controller face upwards, open out the hinged cover protecting the battery-charging
socket and insert the charging jack. When the Ni-Cad battery pack is charging, the appropriate charge
indicator on the connected battery charger will illuminate.
Figure 3-3. Internal Ni-Cad Battery Pack Charging
‘A’
‘A’
Charging Jack
Charging
Socket
Socket
Cover
View on
( )
rotated 180
External Charging. To charge a Ni-Cad Battery Pack, refer to Figure 3-4 below and connect the
CATTRON-THEIMEG
™
battery charger to the mains power supply. Install the charger jack plug to the
external battery charging unit socket as shown. Simply drop the battery pack into the charging unit,
ensuring the battery pack contacts are positioned as shown. When the Ni-Cad battery pack is properly
installed, the appropriate charge indicator on the connected battery charger will illuminate.
Figure 3-4. External Ni-Cad Battery Pack Charging
CHARGING JACK
FROM BATTERY
CHARGER
NI-CAD BATTERY PACK ONLY
PART # 60C-0060N