User's Manual

01/2001, CATTRON - THEIMEG
TM
Section 3, Page 1
Section 3 – Operating Instructions
‘i-Key’ configuration for continuous (FCC Part 90) and non-
continuous (FCC Part 15) transmit applications.
PSAT Pendant Controllers have been approved to comply with both United States FCC Part 15 (non-
continuous transmission) and FCC Part 90 (continuous transmission) applications, and for Canadian
DOC RSS-210 (non-continuous transmission) and RSS-119 (continuous transmission) applications
standards.
Only when the operator installs the ‘i-Key’ is the identifier defined for a particular FCC/DOC
application. Referring to Figure 3-1 below, continuous transmission (TX) configured ‘i-Keys’ will be
identified with an ‘*’ located next to the revision number on its label. Non-continuous TX configured
‘i-Keys’ have only the revision number with no ‘*’. Note that the controller-housing label has both
types of identifiers for each of the FCC and DOC applications standards; however, only the identifier
that matches the ‘i-Key’ label will apply.
Figure 3-1. ‘i-Key’ and Controller Housing Label identifiers.
NOTE: Regulations state that an authorized station-
operating license is required for US FCC
PART 90 or Canadian DOC RSS-119
Continuous Transmissions Applications. If
you need assistance in obtaining this license,
please contact your CATTRON-
THEIMEG
™
inside Sales Department in the
first instance.
AT
Serial No.
1.10
FCC ID: CN2PS, * CN290PS
CANADA: 10071031992, * 1007195678
Housing Label
Non-continuous TX
‘i-Key’ Label
Continuous TX
‘i-Key’ Label
* identifier applies only to units with
continuous transmit application.
AT
Serial No.
* 1.10