Data Sheet

LC840PA
Datasheet
https://www.lairdconnect.com
53
© Copyright 2021 Laird Connectivity
All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]
Figure 18: Scope of the qualification for an End Product Design
The first step is to generate a project on the TPG (Test Plan Generator) system. This determines which test cases apply to
demonstrate compliance with the Bluetooth Test Specifications. If you are combining pre-tested and qualified components in
your design and they are within their three-year listing period, you are not required to re-test those layers covered by these
components.
If the design incorporates any standard SIG LE profiles (such as Heart Rate Profile), it is necessary to test these profiles using
PTS or other tools where permitted; the results are added to the compliance folder.
You are required to upload your test declaration and test reports (where applicable) and then complete the final listing steps on
the SIG website. Remember to purchase your Declaration ID before you start the qualification process, as it’s impossible to
complete the listing without it.
End
Product
Laird RF-PHY
Nordic LL
Host
Layers
Profiles