Data Sheet

LC840PA
Datasheet
https://www.lairdconnect.com
52
© Copyright 2021 Laird Connectivity
All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]
Once all the relevant sections of step 1 are finished, complete steps 2, 3, and 4 as described in the help document. Your new
Design will be listed on the SIG website and you can print your Certificate and Declaration of Conformity.
For further information, please refer to the following training material:
https://www.bluetooth.org/en-us/test-qualification/qualification-overview/listing-process-updates
Note: If using the BL654PA with Laird Firmware and smartBASIC script, you can skip “Controller Subsystem”, “Host
Subsystem”, and “Profile Subsystem”.
11.3 Qualification Steps When Deviating from a Laird End Product Design
If you wish to deviate from the standard End Product design listed under D040166, D041400 or D049255, the qualification
process follows the Traditional Project route, creating a new design. When creating a new design, it is necessary to complete
the full qualification listing process and also maintain a compliance folder for the new design.
The BL654PA design under D040166 incorporates the following components:
Listing reference
Design Name
Core Spec Version
D038622
S140 Host v6.0.0
5.0
D038623
S140 Link layer v6.0.0
5.0
The BL654PA design under D041400 incorporates the following components:
Listing reference
Design Name
Core Spec Version
D039780
S140 Host v6.1.0
5.0
D040756
S140 Link layer v6.1.0x
5.0
The BL654PA design under D049255 incorporates the following components:
Listing reference
Design Name
Core Spec Version
D043345
S140 SoftDevice Link Layer v7.0.1
5.1
D043346
S140 Host Layer v7.0.1
5.1
of these components and it is possible to use them in your new design. Please check with Nordic to make sure these software
components are compatible with the nRF52 hardware.
If your design is based on un-modified BL654PA hardware it is possible use the following process:
1. Reference the existing RF-PHY test report from the BL654PA listing.
2. Combine the relevant Nordic Link Layer (LL) – check QDID with Nordic.
3. Combine in a Host Component (covering L2CAP, GAP, ATT, GATT, SM) - check QDID with Nordic.
4. Test any standard SIG profiles that are supported in the design (customs profiles are exempt).