Users Manual

https://www.lairdconnect.com/iot-devices/iot-
sensors/sentrius-bt7x0-tracker-multi-sensor
7
© Copyright 2020 Laird Connectivity, Inc.
All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]
Several indicator styles are available providing control over how alarm LEDs, audible tones, and vibration motor feedback are
activated when an alarm is triggered. These styles are configurable using the Alarms tab of the BT710 mobile application.
Indicator styles may be selected independently for Alarm 1 and Alarm 2 conditions. The following table (Table 3) describes the
styles available for each alarm indicator.
Table 3: Alarm indicator styles
Indicator
Style
Description/Pattern
Red Alarm LEDs
Off
Red Alarm LEDs will remain off
Style 1
LEDs are lit in a clockwise pattern
Style 2
All red LEDs on, long blink 5 times
Style 3
Top/Bottom fast blink, Left/Right fast blink 2 times
Style 4
Left/Right fast sweep of red LEDs 10 times
Speaker Indicator
Off
No tones will be emitted by the speaker
Style 1
3 fast chirps
Style 2
5 buzz tones
Style 3
3 double-beep tones
Style 4
4 bright tones, repeated 3 times
Vibe Indicator
Off
No vibration will be triggered by the vibration motor
Style 1
3 double-pulse vibrations, repeated 2 times
Style 2
5 double-pulse vibrations
Style 3
5 wave-pulse vibrations
Style 4
4 pulse vibrations, repeated 4 times
The tracker can be cleaned with a mild, non-abrasive detergent. The tracker is not IP-rated/waterproof, so do not immerse it in
water or cleaning fluids.
The tracker does not require any calibration.