Users Manual

https://www.lairdconnect.com/iot-devices/iot-
sensors/sentrius-bt7x0-tracker-multi-sensor
13
© Copyright 2020 Laird Connectivity, Inc.
All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]
The Sentrius™ BT710 mobile application allows a user to configure tracker parameters and update firmware.
To use the Sentrius™ BT710 mobile application, follow these steps:
1. From the applicable app store (Apple or Android) search for and install the Sentrius™ BT710 mobile application on your
mobile device.
2. To connect to the BT710 tracker, make sure it is in Active mode.
3. Tap FIND BT7 DEVICE to discover the tracker(s) within range of the mobile device.
4. Select the tracker to connect. Tracker names start with BT710 and end with the last four digits of the BLE ID as printed
on the back of the Bluetooth tracking device. Once connected, the app displays the current parameter values
configured for the tracker. Parameters are grouped using tabs near the bottom of the page.
Figure 7 - Scan for BT710 trackers