Data Sheet

AC4490
Datasheet
https://www.lairdconnect.com/
11
© Copyright 2022 Laird Connectivity
All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]
Module
Pin
1x1
Pin
Type
Signal Name
Function
reset the transceiver.
16
13
GND
GND
Signal Ground
17
17
I
CMD /Data
When logic Low, the transceiver interprets OEM Host data as
command data. When logic High, the transceiver interprets OEM Host
data as transmit data.
18
15
2
I
AD In
10-bit Analog Data Input
19
20
3
O
DA_Out
10-bit Analog Data Output
20
18
O
In_Range
When logic Low, a client is in range of a server on same Channel and
System ID. Always low on a server radio.
N/A
14
RF
RF Port
RF Interface
N/A
22
I
Reset
Active Low version of UP_RESET. If RESET is used, UP_RESET
should be left floating and if UP_RESET is used, RESET should be left
floating.
1. Must be tied to VCC or GND if not used. Should never be permitted to float.
2. If used, requires a shunt 0.1 μF capacitor at pin 15 followed by a series 1 k resistor.
3. If used, requires a series 1 k resistor at pin 20 followed by a shunt 0.1 μF capacitor.
Notes: All I/O is 3.3 V TTL with exception of 5 V inputs on AC4490-200.
All inputs are weakly pulled High (10 k) and may be left floating during normal operation.
Minimum connections: VCC, VPA, GND, TXD, & RXD.
Signal direction depends on the transceiver.
Leave unused pins disconnected.