User's Manual

Operating manual
Introduction 16
(2) this device must accept any interference received, including interference that may cause undesired
operation.
FCC ID: WJLHT-4
IC 7847A-HT4
Any changes or modifications not expressly approved by novero could void the user's authority to operate
this equipment.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
To ensure compliance with FCC RF exposure requirements, this device must be installed in a location
such that the antenna of the device will be greater than 20 cm (8 in.) away from all persons.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interferen-
ce by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected.
- Consult the dealer or an experienced radio/TV technician for help.
Canada Class B statement:
This Class B digital apparatus complies with Canadian ICES-003
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Bluetooth
Bluetooth technology is used to connect a mobile telephone to the hands-free system fitted in a vehicle. A
pairing process needs to be carried out once only to use the mobile telephone provision with a Bluetooth
mobile telephone.
Some Bluetooth mobile telephones are detected and connected automatically when the ignition is
switched on. For this to happen, the mobile telephone itself and the Bluetooth function in the telephone
must be switched on and all active Bluetooth connections to other units must be disconnected.
There are no charges for the Bluetooth connection.
Bluetooth
®
is a registered trademark of Bluetooth
®
SIG, Inc.
ENTWURF