Installation & Assembly

ASSEMBLY INSTRUCTION
ASME A112.18.1 / CSA B125.1
1. Before Proceeding
We recommend calling a professional if you are
uncertain about installing this product! This product
should be installed in accordance with all local and
state plumbing and building code requirements.
2. Shut Off Water Supplies
Locate the water supply inlets and shut off both the
hot and cold water supply valves. If you are
replacing an existing faucet, remove the old faucet.
Clean the sink surface thoroughly in preparation for
the new faucet.
3. Secure New Faucet
Position the faucet on the sink. If the sink surface is
uneven, a small amount of silicone sealant may be
needed. Secure locknuts on the shank and hand
tighten.
 Model 1210
 Concord Series
 4 Hole Installation
You may need:
For easy installation of your faucet
please:
 READ ALL the instructions,
warnings, care and maintenance
information before beginning
 Purchase the correct water supply
hook-up
4. Connect the Side Spray
Mount the hose guide assembly on the far right hole on
your sink. Insert the spray hose down through the hose
guide and sink. Connect spray hose from under the sink to
the center receiving tube on the faucet.
5. Connect to Water Supplies (Hook-Ups Not Provided).
Flush System/Check for Leaks
Connect the hot and cold water supplies to the shanks as
shown. Remove the aerator. Turn the handle all the way
on. Turn on hot and cold water supplies and flush water
lines for one minute. This flushes away any debris that
could cause damage to internal parts. Check all
connections for leaks. Replace aerator. Re-tighten if
necessary, but do not over tighten.