Installation & Assembly
ASSEMBLY INSTRUCTION
ASME A112.18.1 / CSA B125.1
1. Before Proceeding
We recommend calling a professional if you are
uncertain about installing this product! This product
should be installed in accordance with all local and
state plumbing and building code requirements.
2. Shut Off Water Supplies
Locate the water supply inlets and shut off both the
hot and cold water supply valves. If you are
replacing an existing faucet, remove the old faucet.
Clean the sink surface thoroughly in preparation for
the new faucet.
3. Secure New Faucet
Insert the shank through the sink hole. From
underneath the sink, attach the metal washer
through the shank and tighten the locknut until the
faucet is securely in place.
4. Connect to Water Supplies
Connect the water suppler lines directly to the
supply stops.
5. Flush System/Check for Leaks
Remove spray head. Turn the handle all the way
on. Turn on hot and cold water supplies and flush
water lines for one minute. This flushes away any
debris that could cause damage to internal parts.
Check all connections for leaks. Replace spray
head. Re-tighten if necessary, but do not over
tighten.
Model 1151
Estate Series
1 Hole Installation
You may need:
For easy installation of your faucet
please:
READ ALL the instructions,
warnings, care and maintenance
information before beginning
Purchase the correct water supply
hook-up