Installation & Assembly

Hand-held Shower Assembly
1. Install the Bracket
Insert the plastic anchors into pre-drilled 6mm
holes. Line up the holes on the bracket with inserted
anchors. Insert the screws (included) through the
holes and into the anchors.
2. Connect the Hose and Guide Ring
Insert the rubber washer (included) in the hose
connector and hand tighten the connector to hand-
held shower. DO NOT over tighten as it may break
the connector.
3. Mount the Guide Ring
Mount the guide ring at the desired position with
mounting hardware (included)
4. Connect to Faucet
Insert the rubber washer (included) in the hose
connector and hand tighten connector to the diverter
on the faucet. DO NOT over tighten as it may break the
connector.
5. Flush System
Turn the handle all the way on. Turn on hot and cold
water supplies and flush water lines for one minute.
This flushes away any debris that could cause damage
to internal parts. Your shower faucet is now ready to
use.
Attention:
The toggle on the hand shower is a water saving design/feature. It
is not an on/off switch. The U.S. plumbing code requires a hand
shower not to shut off completely, unless the valve is turned off. It
is called "non-positive shut-off". This is a safety function to remind
users to always shut off the valve. Therefore it is normal for water
to trickle, when the hand shower toggle is at off position. This is
not a leaking defective.