Product Manual

Page | 16Wi-Fi Wind & Weather Station
The Extra Sensor area of your station will show Relative Pressure when you first power up.
Your Water Leak sensor will only read to this area of your station. When you first power up your sensors
and station, your Water Leak sensor will automatically connect. You will see the Pressure and the Sensor
Reception indicator showing in the upper left corner of the Pressure area (Extra Sensor area).
Optional Extra Sensors: Up to 4 additional Thermo-Hygro, Wind Speed, Rain, Water Leak or any
combination of these sensors can read to the EXTRA SENSOR area of your display. Simply press and
release the EXTRA SENSOR button to view these sensors or turn on Auto Scroll.
Purchase Extra Sensors: For additional sensors to read to your station or to the app visit the PARTS TAB
at: bit.ly/s82950
Note: Not all sensors will read to the station. Be sure to check the chart to see if a sensor can read to the
app only, or both station and app.
Relative Pressure (default)
Temperature/Humidity
24 Hr Rain
Water Leak
Contact Probe
Probe
Reading
Add Extra Sensors to your station:
1. Hold the EXTRA SENSOR button 3 seconds, to add a sensor to the station.
2. Install batteries in the sensor, and if the sensor has a TX button, press the TX button to force a signal.
3. Allow up to 3 minutes to view sensor and ID on station.
Note: Once sensor is found the search will stop. Sensor, ID, and type will show for 3 seconds then return
to normal display.
4. Scan sensor bar code ID so it will read in the La Crosse View app.
5. Added sensors will be available for display in Extra Sensor area of station.
WATER LEAK & EXTRA SENSOR AREA
PRESSURE
INHG
Auto Scroll all Extra Sensors
EXTRA SENSOR
EXTRA SENSOR
EXTRA SENSOR
24 HR
EXTRA SENSOR