ASSEMBLY INSTRUCTIONS Scan the QR code for the assembly video. Contact us via email: hofficeservice@gmail.com for more information.
WARNING ! Please read the instructions line by line carefully before assembly, and assemble the item step by step according to the instructions. Don’t use the item before all the components are put together. For any damage or defective parts, please contact our online after-sale service for help. * The features and specifications of the products are subjects to changes without prior notice. * To avoid item damage and personal injury, please strictly observe the instructions when assembling.
Parts Check and make sure you get the components on the list, contact us for any missing Backrest Plastic cover left hand side Control unit ×1 Seat Plastic cover right hand side Allen Key Angle adjuster Base1 Gas lift Connector 2 M8*25 Base2 M5*8 1 Casters Right armrest Plastic cover right hand side Plastic cover Plastic cover left hand side Headrest cushion Left armrest Lumbar cushion
Assembly steps 1.Insert the foot into the groove then lift it up C1 2. Attach wheels Click! C2 ①Clip C1 into the slot of C2； ②Press down the center of C2 to complete the installation 3. Insert the gas lift and plastic cover 4.
Assembly steps ×4 Please notice the handle is on the right side 5. Fix the control unit to the base of the seat 6.Insert the gas lift into the control unit 7.Fix the angle adjuster(B2) onto the side of the seat ×2 8.
Assembly steps 3× 9. Fix the plastic cover(B5) onto the side of backrest 10. Left Side 11.Attach the backrest to the seat ×4 Install the lower screw, but do not tighten it 12. Use the Allen key to make the screws align in the holes correctly and screw them in tightly. Adjust back to align screw hole, install the upper screw, but do not tighten it Repeat on the other side, tighten them after all were installed H 13. Right Side 14.
Function 1 Loading capacity limited to 330lbs Please sit in the center of the chair when adjusting the height. 2 Seat Height adjustment Adjusting knob on the right For rocking 3 Rocking: Pull out the handle to start rocking.
Rocking function Pull out/push in the handle to unlock/lock the tilt when seated upright. Turn the knob clockwise/counter-clockwise to reduce/increase the tile tension.
Assembly steps How to attach the headrest cushion method 1 Put the elastic tapes through the plastic holes and buckle. How to attach the headrest cushion method 2 Put the headrest cushion on the backrest and buckle. How to attach the lumbar cushion? Put the elastic through the aperture, see the picture. Buckle the clips. The cushion can be moved freely. Instructions during use 1. Move the item gently to avoid collision. 2. Keep it away from direct sunlight. 3.
Q& A It is advised to check and tighten the screws on a regular basis, at least every 6 months. Contact us for missing parts, broken parts and defective parts, and we are glad to be helpful. Q: How to attach the seat to the back? A: Screw the seat and the back and do not tighten the screws. Set the back and seat to a perfect angle. Tighten the screws to 100%. Q: How to attach the seat base to the seat A: The “Front” side of the seat base up. Screw the base and the seat and do tighten the screws.
