Use and Care Manual

Step 5:
6.1 As shown in Figure 1, insert the hexagonal bar into the table leg B until the buckle is not
visible.
6.2 Assemble the other end of the connecting rod to the table leg A and screw on the handle.
The handle does not need to be tightened.
Note: As shown in Figure 2 below, it needs to be aligned with the card slot.
6.3 Pull the connecting rod with the handle to the bottom end of the table leg B in the direction
of the arrow as follows.
6.4 Tighten the handle and install the M4 screws, using the provided screwdriver.
6.5 Conect the power cord and motor of the power supply handest as show in the figure.
K
N
2
N
2
Tightened
K
I
3
I
2
I
1
Keep it relaxation
On the card slot