Owner Manual

Installation Instructions for Vessel Sinks
6LACAVA
1. Refer to the sink specs for proper cutout size. For most
above-counter and vessel sinks a standard cutout of 4”-6”
will work. The cutout has to be just large enough so that
the drain assembly can be tightened directly onto the
porcelain.
IMPORTANT! The drain assembly does not attach the
sink to the countertop.
2. Temporarily position the sink over the cutout and make
sure that it is aligned properly, leaving clearance for supply
lines, drain, and faucet assemblies.
3. Make marks with a pencil on the countertop and sink
as a guide for installation.
4. Install the drain and faucet assemblies onto the sink
as applicable.
5. Turn the sink upside down and apply a small bead of
silicone around the bottom edge of the sink, following
the instructions on the label.
6. Place the sink onto the desired location, aligning it with
the guide marks, and press down to ensure a tight seal.
Let the sealant set, as stated in the label’s instructions,
and then connect the supply lines and drain pipes.