Owner Manual

LACAVA 3
Installation for Vanity-Top Sinks
1. Based on the sink’s dimensions and mounting height (usually
30”-35” above floor), decide what support will be needed
to support the vanity and sink.
2. Install proper support for the selected vanity, blocking or
plywood backing. Once the proper support is in place,
finish the wall.
3. Attach the vanity to the wall, bolt it to wall studs or
installed wall support.
4. Make sure the vanity is level and securely installed.
5. If the sink does not have holes to bolt it to wall, go to step 7.
If the sink has holes for bolts on the back wall, place the
sink on the vanity and trace them on the wall. Make sure
the sink surface is level, use rubber bumpers or shims
or sand the edges of the vanity to level the sink perfectly.
6. Remove the sink, drill pilot holes and screw the wood
threaded part of the mounting bolts into the
pilot holes so that the machine threaded portion is sticking
out of the wall. See the details in Wall-mount Sinks secton
on page 2.
7. Install the faucet and drain assemblies onto the sink based
on their instructions.
8. Apply a bead of silicone along the edge of the vanity’s
top edges and along the wall, and place the sink in its
final position.
9. Apply a small bead of silicone around the sink back wall
along the top and sides, and clean any excess following
the instructions on the label.
10. Connect the P-trap and drain arm to the drain stub-out,
and then connect the two water supply lines to the shut
off valves. Check for any leaks.
11. If desired, apply a bead of latex caulk around the edge
between the sink and the vanity and smooth out.