User's Manual

W9922PF PC DVD Playback Card
Page - 5
2. HARDWARE INSTALLATION
2.1. Package Contents
Before you start to install your PC DVD Playback Card you should check that the package
is complete. It should contain the following items:
• 1 LAB DVD Decoder CARD
• 1 Installation CD-title
CABLE:
• 1 VGA Loop Back Cable
2.2. Handling the DVD Decoder Card
WARNING:
 Static electricity can damage your equipment. Do not take the card out of its
static protective bag until you are ready to work with it.
Follow these precautions when handling the board:
• Before you open the static protective bag, touch it to a metal expansion slot cover on the
back of your computer. This drains static electricity from the package and from your
body.
• Do not touch any exposed printed circuitry after opening the package.
• Keep other people from touching the board. They might have a static-electricity
build-up.
• Limit your movement. Movement causes a build-up of static electricity.
2.3. Installing the PC DVD Playback Card
Follow the steps below to install the PC DVD Playback Card into your computer.
1.) Turn off the power to the computer and to the VGA monitor. Unplug (disconnect)
the power cord from the computer.
2.) Disconnect the VGA monitor cable from your PC.
3.) Remove the cover from the computer.
(Refer to your PC user’s manual for specific instructions.)
4.) Locate an available PCI expansion slot.
5.) Remove the slot cover screw and slot cover, if applicable.
6.) Open the protective sleeve containing the PC DVD Playback Card, grasp the
circuit board by the edge of its mounting bracket, and remove it from the
protective sleeve.