Operator's Manual

5 LT0035-1 rev1
Interface Connector
The interface connector is a female RJ25 (6P6C) jack connected as follows:
Pin Color Symbol Parameter
1 White VEN Enable
2 Black SDA I2C Data
3 Red GND Supply Voltage Return
4 Green SCL I2C Clock
5 Yellow VBUS Supply Voltage
6 Blue IRQ Interrupt Request
References
 NXP PN7150: High performance NFC controller with integrated firmware for smart devices
https://www.nxp.com/products/identification-security/rfid/nfc-hf/nfc-readers/pn7150-high-performance-
nfc-controller-with-integrated-firmware-for-smart-devices:PN7150
Regulatory Information
FCC Notices (United States of America)
This device using the integrated antenna has been tested to comply with part 15 of the FCC Rules. The device meets
the requirements for modular transmitter approval as detailed 47 CFR §15.212. It has been assigned the FCC ID
2ASQK-EA00351.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications to this device not expressly approved by LabStrong Corp. could void
the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.