LabStrong EA00351 NFC Controller OPERATOR’S MANUAL
Table of Contents Safety Information – Read This First! .......................................................................................................... 3 Introduction ................................................................................................................................................... 4 Specifications ................................................................................................................................................ 4 Interface Connector ..
Safety Information – Read This First! Throughout this manual, the signal words Warning, Caution, and Notice are used to draw your attention to important messages about the proper use of this product. Carefully read all the safety messages in this manual. If you do not understand any part of this manual and need assistance, contact LabStrong.
Introduction The LabStrong model EA00351 NFC Controller is a standalone NFC interface board based on the NXP PN7150, a full NFC controller solution with integrated firmware and NCI interface designed for contactless communication at 13.56MHz. It is compatible with NFC forum requirements, meeting compliance with Reader mode, P2P mode, and Card Emulation mode standards. The EA00351 NFC Controller features an integrated high-performance RF antenna to ensure high interoperability levels with NFC devices.
Interface Connector The interface connector is a female RJ25 (6P6C) jack connected as follows: Pin Color Symbol Parameter 1 2 3 4 5 6 White Black Red Green Yellow Blue VEN SDA GND SCL VBUS IRQ Enable I2C Data Supply Voltage Return I2C Clock Supply Voltage Interrupt Request References NXP PN7150: High performance NFC controller with integrated firmware for smart devices https://www.nxp.
The FCC requires the OEM to be notified that any changes or modifications not expressly approved by LabStrong may void the user’s authority to operate the equipment. While an application of the EA00351 NFC Controller in a product is not required to obtain a new FCC authorization for the module, this does not preclude the possibility that some other form of authorization or testing may be required for that end product.
of twelve (12) months, the parts required to repair such defect. Outside the continental United States or Canada, the warranty period covers for twelve (12) months the parts required to repair such defect. Labor outside of the continental United States or Canada is not covered. The warranty period for this product begins from date of shipment to the original buyer.
