Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Hardware
NXT Go Owner’s Manual, LBL-00145, MAN2030 96
Hardware
6.1 Laptop Personal Computer
For information on the specifications of the laptop personal computer provided with the NXT
System, refer to Table 15: Equipment Specifications in the Appendix section beginning on
page 110.
6.2 Bluetooth Dongle NXT
The Bluetooth Dongle NXT, as shown in Figure 75, allows modules such as the Roam NXT
and Urocap NXT to wirelessly communicate with the NXT system.
Figure 75: Bluetooth Dongle NXT
6.3 Remote Control NXT
The Remote Control NXT (Figure 76) is a battery powered device which connects to the
computer wirelessly via Bluetooth technology. This device allows the user to control the NXT
System from a distance.
Figure 76: Remote Control NXT Membrane Icons
The Remote NXT key icons and their functionalities are described in Table 9 below.
Status DRAFT Effective