Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Synergy Software
NXT Go Owner’s Manual, LBL-00145, MAN2030 71
4.6 UDS Intelligence
Quality Control (QC)
The UDS Intelligence capabilities within Synergy allow the software to provide feedback on
user adherence to required standards and procedures throughout the study.
The Quality Control window can be accessed by selecting the Quality Control Icon on
the Slide Sidebar at any time during the study. The quality feedback provided in the Quality
Control window will vary based on the workflow step.
4.6.1.1 Pre-test Quality Control
During the Preview Phase of the Procedure workflow step, the Quality Control window will
display Pre-test Quality Control.
Pre-test QC displays the modules which must be completed to prepare the NXT
system for the recording phases of the study. The user can expand each module
to show actions required for submodules by using the plus/minus boxes.
The color of the module indicates its status. If a submodule requires attention the
main module will reflect this in its assigned status (Figure 60).
a. If the color of the module is red, action is required. Grey submodules are
provided to give guidance on how to resolve requirements; for additional
information, hover the curser over the red modules.
b. An amber colored module indicates a recommended action.
c. Green indicates the completion of all actions for the setup of the module.
d. Blue submodules provide recommended actions regarding patient set-up.
See Figure 60 below for examples of the color coding of the modules in the preview phase.
Figure 60: Pre-test QC
Red Module
Blue Submodule
Green Module and Submodules
Amber Module
Plus/Minus Box
Status DRAFT Effective