Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Synergy Software
NXT Go Owner’s Manual, LBL-00145, MAN2030 70
NOTE: fixed events, such as pump markers, cannot be moved or deleted from the
graph.
Use the vertical red marker to zoom in on a specific portion of the graph. Left click
and drag the red marker to select the portion of the graph to expand. Use the
Previous Zoom button in the control panel to return to the previous magnification
or click Zoom 100% to view the full graph.
Move the phase boundaries in the graph. Phase boundaries are markers that show
where each phase of the test started and ended. Follow the instructions below:
a) Press the Ctrl + Shift keys together. This will cause the Review window to
grey out.
b) Move the vertical red marker to the phase boundary line, click and then drag
the phase boundary line to the desired location on the graph.
c) Verify that all changes are saved.
Once review of the study is complete and changes are saved, click the Close button to
return to the main window. Alternatively, click the Report button to load the Report
window beside the Review window in split screen. To exit the review section of the split
screen, click the Close button. To exit the report section of the split screen, click Finish.
Status DRAFT Effective