Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Synergy Software
NXT Go Owner’s Manual, LBL-00145, MAN2030 69
Figure 58: EMR Sending Status
NOTE: The Send to EMR button will not be accessible when using the Preview
Changes feature to view report configuration. Click Apply Changes on the report
Configuration Settings panel to access the Send to EMR button.
Review
The Review workflow step allows the user to assess the information recorded during the
study. To review the study, select the patient in the Patients section, click the Studies tab
in the Patient Details section, and click the Review button; the Review window will then
load (Figure 59).
Figure 59: Review – FreeFlow Study
While in the Review window, the user can:
Access, edit, and review content in the Slide Side Bar.
Review UDS Intelligence Score and Quick Results.
Edit patient details and patient history.
Select images for inclusion in the report.
Edit Study Configuration settings using the Review Editor available under the
Settings icon. Limited settings are available in the review phase.
Review and Edit information in the Graph section.
Use the red marker to move, add, or delete events in the graph. Left click on a
marker and drag to move it to a new position. Right click on the location where a
marker is required and select the Marker Type from the resulting menu to insert
an event marker. Right click the event marker and select Delete Marker to
remove an event marker from the graph.
Status DRAFT Effective