Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Synergy Software
NXT Go Owner’s Manual, LBL-00145, MAN2030 67
Enter any comments in the window and select the save icon on the
Comments window’s toolbar.
Ensure the Comments option is checked under Report content in the
Configuration settings. To edit comments from the Configuration Settings,
open the Comments dropdown menu and select the click to enter text! option.
This will open the Comments window.
The Comments dropdown menu includes a secondary dropdown called Header
title. Open the dropdown and select the click to enter text! option to assign a
heading to the comments section of the report (Figure 56).
Figure 56: Comments and Header Title Drop Down Menus
Click the Apply Changes button to save changes to the report.
4.5.4.3 Quick Results and Nomograms
Quick Results and Nomograms generated by Synergy are intended for use as quick
references complementary to the complete study data.
Study results are calculated from the data recorded by NXT system transducer
channels during the procedure; values are rounded to a single decimal place for
user viewing. Calculations and nomograms are calculated using the raw data
collected during the study, not from the rounded values provided for ease of
reading.
Nomograms are graphical representations of particular results from the procedure.
Nomograms may be generated through the Report content drop down menu
. Check the Nomograms option and Apply Changes to add
this feature to the report. Nomograms are intended as a summary analysis only.
Quick Results and Nomograms may be viewed during the study on the Slide
Sidebar under the associated icon .
Status DRAFT Effective