Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Synergy Software
NXT Go Owner’s Manual, LBL-00145, MAN2030 61
Start Study Button
The Start Study button (Figure 49) launches Synergy into the Preview Study phase.
Figure 49: Start Study Button
Once all study inputs are received the button will shift to blue. When greyed out the button
cannot be activated. Hover the curser over the Start Study button to activate tool tip
functionality which will suggest troubleshooting options, as shown in Figure 50.
Figure 50: Start Study Button Tool Tip
NOTE: Always ensure patient and study of choice are selected and that all hardware
channels and devices are linked before attempting to start a study.
IMPORTANT: The Synergy software will not allow the user to begin a study if the
Roam NXT or Urocap NXT have under 15% battery charge available. To activate the start
study button when the device battery is below 15%, connect the device to the applicable
charging hub.
Connect the Urocap NXT to power using the NXT Magnetic Pogo Pin Cable; Urodynamic
studies cannot be completed with the Urocap NXT seated within the NXT Hoop. Refer to the
Urocap NXT section on page 105 for information on using the NXT Magnetic Pogo Pin Cable.
4.5 Workflow Steps
Studies in Synergy have standard workflow steps for users to complete. Standard workflow
steps are Procedure, Questionnaire, Report, and Review. These steps can be
customized and viewed through the Workflow Configuration window. Refer to the
Customizing Workflows section on page 56.
The Procedure workflow step has a different phase breakdown depending on the type of
study selected. Refer to the Workflows section on page 55 for phase break down per study
workflow.
This section provides an overview of workflow steps, their phases, and their functions from
the start to the completion of the study.
Status DRAFT Effective