Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Synergy Software
NXT Go Owner’s Manual, LBL-00145, MAN2030 59
Click the Phases tab on the Workflow Configuration Window. Select a phase
to customize from those listed. Scroll down to the control panel section located at
the bottom of the window. Refer to Figure 45.
Figure 45: Workflow Configuration Window - Control Panel
Verify that the desired number of Control Panel buttons are provided. Use the
Row Count and Column Count fields to increase or decrease the number of
buttons shown in the control panel.
To add or change a button’s label, click on the button to launch the select action
for button window (Figure 46). Select the label of choice and press OK. To
remove a button label, click the button to be adapted and select Empty Button in
the action window; click OK to implement the change.
Figure 46: Action Window – Adding, Changing or Emptying Button Label
Status DRAFT Effective