Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Synergy Software
NXT Go Owner’s Manual, LBL-00145, MAN2030 58
Channels: Channel Name, Channel Position, Channel Type, Unit, ScaleMax,
ScaleMin, Color, Hardware channel, Chartdown Sampler
Phases: Phase Name, Visible Channels, Channel Values Shown Separately,
Workflow Additional Configuration Items, Additional Status Bar Items, Fluid
Density Settings, Control Panel
Events Summary: Select Event Names for inclusion in the Event Summary and
view Marker type.
The following settings tab is available under the Questionnaire Workflow Step:
Settings: Automatically Execute Questionnaire
The following setting tab is available under the Report Workflow Step:
Settings: Silent Report Execution, Landscape Graph Scaling
The following setting tab is available under the Review Workflow Step:
Settings: Automatically Execute Review, Control Panel
4.4.2.2 Customizing Control Panel
The control panel is a customizable space available in each study phase window providing
control buttons that allow the user to place study markers, control the pump, and perform
other additional tasks. Buttons available in the control panel are standardized per study
phase for default workflows. Customize buttons per study phase using custom workflows.
IMPORTANT: Workflows cannot be re-configured while a study is in progress. All
workflow settings must be adjusted prior to beginning a study.
To customize the control panel, first create a custom workflow as instructed in the
Customizing Workflows section on page 56. Then follow the instructions below to customize
the control panel per study phase:
Status DRAFT Effective