Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Synergy Software
NXT Go Owner’s Manual, LBL-00145, MAN2030 42
Synergy Software
This section provides an overview of Synergy software functions and features based on
standard workflow:
Accessing Synergy
i. User Access Control
ii. Sections and Icons in the Main Window
Overview of Synergy Setup Features Required to Start a Study
i. Patient Management
ii. Study Management
Overview of Synergy Functions Available During a Study
i. Workflow Steps
Study Process Review
i. UDS Intelligence
4.1 User Access Control
Login
To login to Synergy, follow the steps below.
Double-click the Synergy shortcut icon on the desktop or launch the Synergy
application from the LABORIE Dashboard. The Synergy Login Page will be
displayed (Figure 26). Upon first login ensure to accept the End User License
Agreement.
Input account User Name and Password into the Synergy Login Page. Initial
access information will be set up during system install. Users must update all
access information upon first use; do not use generic or universal login
credentials. Additional access accounts may be created by utilizing the User
Setup function.
Figure 26: Synergy Login Page
Status DRAFT Effective